AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Master reboot profile background3/1/2023 If you already have an open ticket with a support agent, please reply to the last email sent. based support staff by Submitting a Request or by chatting with our Live Agents. If you are still experiencing concerns, please contact our U.S. If you still experience the issue, move forward with the following applicable troubleshooting steps:ĪcuRite Iris™ (5-in-1) Inaccurate RainfallĪcuRite Iris™ (5-in-1) Inaccurate Wind ReadingsĪcuRite Iris™ (5-in-1) Inaccurate Temperature or HumidityĪcuRite Iris™ (5-in-1) Temperature Reading Too High If you are using a High Definition display unit such as model #06058M or #06088M, please use the following reset linked below:ĪcuRite Iris™ (5-in-1) High Definition Display Reset Let the units sit within a couple of feet of each other for approximately 5 minutes or until you see a solid sensor signal.Reinstall batteries and/or power cord into the display unit then immediately press and hold the reset button again for 20 seconds if applicable.Reinstall the batteries in the outdoor sensor.Change the A-B-C switch on both units to a new, matching channel then press and hold the reset button for 20 seconds if applicable.Bring both the sensor and display unit together and power down by removing all batteries from each and/or removing the power cord.NOTE: It may take approximately 5 minutes for the display unit and sensor to synchronize after batteries are replaced. We do not recommend using heavy-duty or rechargeable batteries. Use standard alkaline batteries (or lithium batteries in the sensor when the temperature is below -4✯/-20✬).pgprofile. Also, this parameter affects size of a sample - the more objects you want to appear in your report, the more objects we need to keep in a sample. Units should be placed at least 3 feet (.9 m) away from electronics that may interfere with wireless communication (such as TVs, microwaves, computers, etc). pgprofile.topn 20 - Number of top objects (statements, relations, etc.), to be reported in each sorted report table.Under optimal conditions, the units can be located up to 330 ft (100 m) of each other. Relocate the display unit and/or the AcuRite Iris™ (5-in-1) sensor.You may choose A, B, or C but both units must match to sync up. Verify that the A-B-C switch in the battery compartments of both the display and sensor are set to the same letter.You would want to ensure the following first: The outdoor temperature is -40 degrees. No outdoor temperature (showing dashes).Symptoms of the sensor not connecting to the display could include: The following reset steps can be performed to correct issues of the sensor not connecting to the display.
0 Comments
Read More
Leave a Reply. |